 |
 The bracket return spring is installed by the compression spring method. Therefore, this unit is compact and provides good workability and safety.
The ISO spring is applied for the return spring.
Selection of the spring type is available in accordance with weights of bending edges.
An entrance angle of the bending edge is 55｡.
Uses same drivers (OHD145 series and OHD230 series) as the single link unit.
Uses same bending edges (OHD145 series and OHD230 series) as the single link unit.
There are two types of installation seat widths for bending edge.
|
| OHPS185-55D-H |
| OHPS185-55D-M |
| OHPS280-55D-H |
| OHPS280-55D-M |
| OHPK185-55D-H |
|
|
|
| OHPK185-55D-M |
| OHPK280-55D-H |
| OHPK280-55D-M |
|
|
( )Former Part No |
page top