The bracket return spring is installed by the compression spring method. Therefore, this unit is compact and provides good workability and safety.
The ISO spring is applied for the return spring.
Selection of the spring type is available in accordance with weights of bending edges.
An entrance angle of the bending edge is 70.
Uses the driver (OHD70 series).
Uses the bending edge (OHD70 series).
Installation face of the bending edge is provided.

OHPS185-70D-H OHPS185-70D-M OHPK185-70D-H OHPK185-70D-M

( )Former Part No