yDO!BOOKEƒy[ƒWƒŠƒ“ƒNz
bearing@@@165 / 392

BOOK‚ð‚Ý‚é

10•bŒã‚ÉBOOK‚̃y[ƒW‚Ɉړ®‚µ‚Ü‚·


TCB Oiles Techmet B Bushings Made-to-order I.D. O.D. ƒÓd ƒÓD 4 5 6 7 8 10 12 15 20 568 10 12 14 15 16 18 20 22 78 10 12 14 16 17 18 20 23 25 0504 0505 0605 0606 0806 1006 1206 1607 0508 0808 1208 0610 0810 1010 1210 1410 1510 1610 1810 2010 2210 0812 1620 1820 2020 2220 1415 1515 1615 1815 2015 œAll Oiles Techmet products have I.D. machining allowance (0.2 mm for the diameter) and available on order. ¦The joint causes no influences upon rotation of the shaft. Be careful when press-fitting so that the joint is not @at the position to which the maximum load is applied. ¦Chamfering of inner or outer diameters less than ƒÓ10 mm is done only to remove burrs. T 1.0 C0.3 1.5 C0.5immj T 1.0 0.5 1.5 0.8 immj T i20‹}5‹j PTFE with filler ƒÓd ƒÓD L L Bushing ƒÓd ƒÓD joint¦ 6.3 i @j chamfer Motion direction Mating shaft Housing H7 Shaft 0.8 i @j Length L@Tolerance 0 |0.3 a b a b Specify Part No. by required I.D. and length. (e.g.) I.D. is 12mm and length is 8mm. TCB - 1208 Tolerance {0.055 {0.055 {0.055 {0.060 {0.060 {0.065 {0.065 {0.070 {0.075 {0.080 {0.080 {0.025 {0.025 {0.025 {0.030 {0.030 {0.035 {0.035 {0.035 {0.040 {0.045 {0.045 a: O.D. chamfering for the bushing I.D. of ƒÓ10 or more b: I.D. chamfering for the bushing I.D. of ƒÓ10 or more Back metal Parts No. ¦Outer diameter is measrued by exclusive gauge. 164 Selection Guide Product Information Plastic Bearing Multi-layer Bearing Metallic Bearing Air Bearings Technical Slide Shifter Information Corporate Profi le