yDO!BOOKEƒy[ƒWƒŠƒ“ƒNz
bearing@@@179 / 392

BOOK‚ð‚Ý‚é

10•bŒã‚ÉBOOK‚̃y[ƒW‚Ɉړ®‚µ‚Ü‚·


HPF Oiles Hiplast N Flange Bushings Specify Part No. by required I.D. and length. (e.g.) I.D. is 8mm and length is 8mm. HPF - 0808 ¦The joint causes no influences upon rotation of the shaft. Be careful when press-fitting so that the joint is @not at the position to which the maximum load is applied. Mating shaft Flange bushing 0.5 ƒÓF ƒÓd ƒÓD . joint¦ t 6.3 i @j chamfer Housing H7 Shaft 0.8 i @j t 0.5}0.05 . ƒÓd ƒÓD ƒÓF Motion direction Shaft O.D. Flnage Size Tolerance ƒÓD 5 6 8 10 12 15 I.D. ƒÓd 4568 10 12 15 5679 11 13 16 ƒÓF 8 10 11 13 16 18 22 4568 10 12 15 Thickness t Tolerance 0.5 0.5 0.5 0.5 0.5 0.5 0.5 }0.05 }0.02 }0.02 }0.02 }0.02 }0.02 }0.02 0405 0505 0606 0808 20 1220 1520 0510 0610 1010 1212 0815 1015 1515 Length . @Tolerance }0.3 |0.100 |0.040 |0.040 |0.040 |0.040 |0.040 |0.040 {0.112 {0.055 {0.055 {0.055 {0.058 {0.058 {0.058 ¦The HPF0405, HPF0505, HPF0510, HPF1515 and HPF1520 have straight flange bottoms. ¦The I.D. tolerances after press fitting are the reference values measured in the condition where the bushings are inserted into the housings @and in close contact with them. |0.055 |0.055 |0.055 |0.055 |0.058 |0.058 |0.058 |0.040 |0.040 |0.040 |0.040 |0.040 |0.040 |0.040 I.D. tolerance after press fitting (reference) Parts No. 178 Selection Guide Product Information Plastic Bearing Multi-layer Bearing Metallic Bearing Air Bearings Technical Slide Shifter Information Corporate Profi le