yDO!BOOKEƒy[ƒWƒŠƒ“ƒNz
bearing@@@189 / 392

BOOK‚ð‚Ý‚é

10•bŒã‚ÉBOOK‚̃y[ƒW‚Ɉړ®‚µ‚Ü‚·


GeneralEUnderwaterEUnder Seawater œApplicable to rotational, oscillating, and reciprocating motion. œBe sure to apply grease supplied with the product to the inner sliding surface before assembling the bearing. Run in the bearing. œMay be used over the maximum allowable speed or maximum allowable PV value in short-time intermittent operations. Inquire us in such a case. œUse a stainless steel or chrome-plated (30ƒÊm or more) mating shaft when using the product in water, in seawater, in a water-splashed place, on the sea, etc. œUse a mating shaft made of high-grade stainless steel with higher corrosion resistance or plated with thicker chrome when using the product in severe corrosive conditions. Supply grease for rust prevention. œProvide the bushing with a set screw when using the product for high loads. œUsable without the need for lubrication in the air and water. Use lithium grease with extreme pressure additive if greasing is required. 100 I.D. ƒÓd 7090100 7595100 80100100 90110100 100120100 110130100 120140100 130150100 140160100 150170100 160180100 –170190100 –180200100 –190210100 110 80100110 110130110 120 100120120 120140120 130 130150130 140 140160140 150 130150150 150170150 160180150 –170190150 –180200150 –190210150 –200230150 90 –200230200 200 709090 8010090 9011090 12 15 16 18 20 25 30 35 40 40 45 50 50 55 60 65 70 75 80 90 100 110 120 130 140 150 160 170 180 190 200 L C0.3`1 15‹ 2`5 10‹ ƒÓdE7 ƒÓDr6 R1.5`4 2.5`8.5 Length L@Tolerance |0.1 |0.3 {0.031 {0.026 {0.026 {0.026 {0.037 {0.032 {0.032 {0.046 {0.046 {0.040 {0.040 {0.040 {0.040 {0.053 {0.053 {0.053 {0.046 {0.046 {0.046 {0.060 {0.060 {0.052 {0.052 {0.068 {0.068 {0.065 {0.065 {0.065 {0.065 {0.078 {0.078 {0.013 {0.008 {0.008 {0.008 {0.016 {0.011 {0.011 {0.021 {0.021 {0.015 {0.015 {0.015 {0.015 {0.023 {0.023 {0.023 {0.016 {0.016 {0.016 {0.025 {0.025 {0.017 {0.017 {0.028 {0.028 {0.025 {0.025 {0.025 {0.025 {0.032 {0.032 1.6 I.D. tolerance after press fitting (reference) 188 Selection Guide Product Information Plastic Bearing Multi-layer Bearing Metallic Bearing Air Bearings Technical Slide Shifter Information Corporate Profi le