yDO!BOOKEƒy[ƒWƒŠƒ“ƒNz
bearing@@@258 / 392

BOOK‚ð‚Ý‚é

10•bŒã‚ÉBOOK‚̃y[ƒW‚Ɉړ®‚µ‚Ü‚·


30B Oiles 300 Bushings (Thin wall) œ Use Oiles 300 in lubrication oil or with periodic lubrication. Motion direction Mating shaft Bushing ƒÓd ƒÓD 1.6 i @j h7 Housing H7 chamfer 6.3 i @j Parts No. Specify Part No. by required I.D., O.D., and Length. (e.g.) I.D. is 8mm, O.D. is 10mm, and length is 12mm. 30B - 081012 T L I.D. O.D. ƒÓd Tolerance ƒÓD Tolerance 5 568 10 12 12 14 14 16 16 18 20 78 10 12 14 16 16 18 18 20 22 24 050705T 060805T 6 050706T 060806T 081006T 8 050708T 060808T 081008T 101208T 121408T 121608T 10 060810T 081010T 101210T 121410T 121610T 141610T 141810T 161810T T162010 12 081012T 101212T 121412T 121612T 141612T 141812T 15 101215T 121415T 121615T 141615T 141815T 161815T 162015T 20 121420T 121620T 141620T 141820T 161820T 162020T 182220T 202420T 30 182230T 202430T {0.058 {0.058 {0.062 {0.068 {0.081 {0.081 {0.081 {0.081 {0.081 {0.089 {0.089 {0.105 {0.034 {0.034 {0.034 {0.041 {0.041 {0.041 {0.041 {0.041 {0.041 {0.049 {0.049 {0.049 {0.030 {0.030 {0.034 {0.034 {0.047 {0.047 {0.047 {0.047 {0.047 {0.047 {0.047 {0.063 ¦The I.D. tolerance after press fitting is for reference only. Length L@Tolerance 0 |0.2 I.D. tolerance after press fitting (reference) C0.3 C0.3 C0.3 C0.3 ƒÓd ƒÓD L {0.019 {0.019 {0.019 {0.023 {0.023 {0.023 {0.023 {0.023 {0.023 {0.028 {0.028 {0.028 {0.012 {0.012 {0.012 {0.012 {0.020 {0.020 {0.020 {0.020 {0.020 {0.020 {0.020 {0.030 {0.040 {0.040 {0.040 {0.046 {0.054 {0.054 {0.054 {0.054 {0.054 {0.062 {0.062 {0.072 The dimensional tolerances are the values measured at +25Ž. 257Selection Guide Product Air Bearings Metallic Bearing Multi-layer Bearing Plastic Bearing Information Technical Corporate Profi le Information Slide Shifter