【DO!BOOK・ページリンク】
bearing   289 / 392

BOOKをみる

10秒後にBOOKのページに移動します


■Installing Several Shift Tables on Dual-axis Rails Topsy-turvy, Laterally, or Vertically (S Type) @Use knock pins for both the guide rails and shift tables if vibrations or large impact loads are applied to them. The fixing holes of the guide rails may be used at intervals of several holes for the knock pins. @Make sure that two rails are in parallel. (0.2 mm or less) AInsert the shift tables with adjusted clearance into the guide rails. BFix the mating plate to the shift tables temporarily, make sure that the tables move smoothly, and fix the mating plate finally. CRecheck parallelism and clearance of the rails if movement is not smooth.  If large moment loads are applied, the resistance increases. AIt is recommended that a mating plate with high parallelism should be used. If sufficient parallelism cannot be secured for reasons of machining, carry out adjustment with shims so that the guide rails and shift table are in good contact. Mating plate ■Other Instructions 288 Selection Guide Product Information Plastic Bearing Multi-layer Bearing Metallic Bearing Air Bearings Technical Slide Shifter Information Corporate Profi le