yDO!BOOKEƒy[ƒWƒŠƒ“ƒNz
bearing@@@79 / 392

BOOK‚ð‚Ý‚é

10•bŒã‚ÉBOOK‚̃y[ƒW‚Ɉړ®‚µ‚Ü‚·


80UP Oiles Pillow 80 Pillow Type Units Parts No. I.D. Outer dimensions Form ƒÓd Tolerance 68 10 12 15 17 20 80UP-06 80UP-08 80UP-10 80UP-12 80UP-15 80UP-17 80UP-20 M4 M4 M5 M6 M6 M8 M8 12 15 16 18 21 24 26 b 7 10 11 13 16 18 20 W 5 5 6 7 7.5 9.5 10 S2 14 18 22 26 30 34 38 c 79 11 13 15 17 19 h Bolt size Tightening torque kkgfEcml 20i15j 30i20j 45i30j 75i50j 90i60j 120i75j 150i90j a 39 45 53 60 67 80 88 S1 4.5 4.5 5.5 6.5 6.5 8.5 8.5 p 26 30 36 42 48 56 63 {0.020 {0.025 {0.025 {0.032 {0.032 {0.040 {0.040 {0.068 {0.083 {0.083 {0.102 {0.102 {0.124 {0.124 13 10 876 11 9 ƒÆ‹ S1 b c h ƒÓd S2 W Outer case (reinforced plastic) Oiles 80 pa œThe recommended shaft dimension and finishing grade are h7 and 3.2 ƒÊmRy or less, respectively. The shaft dimension of e7 is recommended if used at the temperature of 0‹C (32‹F) or less. œApply grease or oil to the sliding surface. œUse bolts and washers to mount the product. œThe allowable tightening torques shown in parentheses are the values if no washer is used. œFind the surface pressure from the pressure receiving area (ƒÓd~W), refer to the service ranges shown on page 76, find the allowable load, and choose the proper size. Specify Part No. by required I.D. (e.g.) Diameter is 12mm. 80UP - 12 allowable alignment angle ƒÆ‹ Parts No. The dimensional tolerances are the values measured at +25Ž. 78 Selection Guide Product Information Plastic Bearing Multi-layer Bearing Metallic Bearing Air Bearings Technical Slide Shifter Information Corporate Profi le