【DO!BOOK・ページリンク】
plastic_mold   18 / 88

BOOKをみる

10秒後にBOOKのページに移動します


Slide Core / Round Inclined Pin The unit can be installed from either upper or lower directions. Attention: Take measures to prevent an inclined pin holder and other parts from slipping off a mold. Attention: Spread grease on sliding surfaces when you install a unit. There are two methods of installing an ejector plate, A and B. Select the fixing screw according to each method of A and B. Fixing screw Fixing screw Fixing screw Recommendation torque of tightening screw Screw diameter Fixing screw Fixing screw EP upper EP lower EP upper EP lower EP upper EP lower EP upper EP lower Inclined pin Inclined pin Inclined pin Inclined pin ●Installation from upper direction : A  fixing the screw into the ejector plate. ●Installation from upper direction : B  fixing the screw into the body of the unit. ●Installation from lower direction : A  fixing the screw into the ejector plate. ●Installation from lower direction : B  fixing the screw into the body of the unit. Product code ●If there is no structure such as spacer of guide unit to prevent an inclined pin holder from slipping off and an inclined pin is not fixed into an inclined pin holder, an inclined pin holder may slip off a mold when a mold is inclined or reversed. Take measures beforehand to securely prevent an inclined pin holder and other parts from slipping off a mold.