【DO!BOOK・ページリンク】
plastic_mold   76 / 88

BOOKをみる

10秒後にBOOKのページに移動します


The joint causes no influences upon rotation of the shaft. Be careful when press-fitting so that the joint is not at the position to which the maximum load is applied. Motion direction is in both the rotation, oscillation and/or reciprocation. *Inner-diameter tolerance after press fitting is a reference value. *The inner diameters of 3 to 28 are shown on page 73 and 74. Guide Parts Standard How to Order Chamfer Housing Shaft Mating shaft Joint