【DO!BOOK・ページリンク】
press_die   102 / 428

BOOKをみる

10秒後にBOOKのページに移動します


OILES #2000 wear plates are applied to the driver cam plate and base lower plate. Therefore, high wear resistance and galling resistance are achieved. High performance and compact design For Piercing/Trimming/Flanging ODST series is a Die mount type cam unit that is suitable for piercing, trimming and flange operations. Inclined angle Inclined angle Inclined angle Inclined angle Inclined angle ■Feature ●Due to application of OILES #2000 wear plate, superior wear resistance and galling resistance are achieved. ●Compact design with short unit length. ●An inclined angle type, which corresponds to maximum of 15° and 5° pitch, increments are also available (ODST90-55 and ODST160 series only). ●The unit width and mounting face width are about the same, making for superior compactness. Model Machining ability Machining stroke Unit Mounting face (One-million stroke) Width Length Height Width Height The table on the right indicates the sliding performance that corresponds to the Cam working load in accordance with the production volume. When the unit is operated for higher efficiency than the specified working load, abnormal wearing or galling may occur on the sliding surface. Selection of appropriate Cam working load by production volume Model Machining ability (One-million stroke) Machining ability (Half-million stroke) , , , , , , 100