【DO!BOOK・ページリンク】
press_die   74 / 428

BOOKをみる

10秒後にBOOKのページに移動します


●Manufacturing Control Numbers, unique to each unit, are assigned to main part; base, cam slide, etc.                                       Since the sliding areas of the unit have been controlled for their clearance during manufacturing, the manufacturing control No. of each part must be confirmed when reassembling. This will ensure proper assembly of matched ports. ●Be sure to clean the cam unit thoroughly. It is important to check all wear surfaces for foreign objects or metal chips. ●Lubricate the slide, gibs, wear-plates and all other wear surfaces with lithium grease. ●Remove  . Slide   back ward. Lift   up. ●Remove  . Remove   and lift the cam slide up. :Bolt,  :Cam slide,  :Guide shaft :Bolt,  :Cam upper plate 72