bearing   141 / 392



Dimensional inspection and chamfering of Oiles Drymet ST Oiles Drymet ST is dimensionally inspected before shipping as indicated below: 1. The O.D. is cheeked by "GO" and "NO GO" ring gauges. 2. The I.D.mounted in the "GO" ring gauge is checked by plug gauges. 3. The "GO" ring gauge stands for the upper limit and the "NO GO" ring gauge the lower limit of the O.D. tolerance. 4. Chamfering: Both ends of the I.D. and O.D. are chamfered as shown in the right diagram except those with the ID of 9mm or less which are not chamfered. Free gap “GO” “NO GO” Thickness L 20°±5° Both ends of I.D. 0.3 to 0.5×45° Both ends of O.D. 0.5 to 1.0 Thickness 1.0mm : 0.5mm Thickness 1.5mm : 0.8mm Thickness 2.0mm : 1.0mm 〔 Th ickness 2.5 mm  : 1.0mm〕 0 −0.3 140 Selection Guide Product Information Plastic Bearing Multi-layer Bearing Metallic Bearing Air Bearings Technical Slide Shifter Information Corporate Profi le