Oiles Lutech GP Polyacetal bearings with fillers Feature ●Serviceable without the need for lubrication. ●Plastic parts may be used as mating parts. ●Features low coefficient of friction and low variations caused by loads. ●Prevents abnormal noises in plastic-to-plastic sliding applications. ●Has superior wear resistance. ●Injection-molded and can be made in complicated shapes. Has good mass productivity. Service range Mating material Lubrication condition Service temperature range ℃ Allowable max. pressure P N/mm｛2 kgf/cm2｝ Allowable max. velocity V m/s｛m/min｝ Allowable max. PV value N/mm2・m/s｛kgf/cm2・m/min｝ Plastic 3.92｛40｝ 0.33｛20｝ 0.163｛100｝ Metal 9.81｛100｝ 0.67｛40｝ 0.327｛200｝ ※The values shown above are typical values, not the standard values. Dry −40〜＋80 Specific gravity Tensile strength Tensile elongation at break Flexural property Flexural modulus Hardness Izod impact strength (with notch) Deflection temperature under load 1.82 MPa UL incombustibility ASTM D 792 ASTM D 638 ASTM D 638 ASTM D 790 ASTM D 790 ASTM D 785 ASTM D 256 ASTM D 648 UL94 1.35 48.0｛490｝ 40 64.8｛661｝ 2,006｛20,471｝ HRM65 36.8｛3.75｝ 107 HB Mechanical properties . N/mm｛2 kgf/cm2｝ ％ N/mm｛2 kgf/cm2｝ N/mm｛2 kgf/cm2｝ . J/m｛kgfcm/cm｝ ℃ File No.E78113 87Selection Guide Product Air Bearings Metallic Bearing Multi-layer Bearing Plastic Bearing Information Technical Corporate Profi le Information Slide Shifter